[. . . ] –¡ CHECK : Solidly constructed floor (Not Carpeting and soft tile surfaces) 2. [. . . ] To keep the drain hose spout bent, use the supplied plastic hose guide. Laundry tub must be no shorter than 18 in (46 cm) and no longer than 96 in (245 cm). Do not insert the drain hose too far into the stand pipe: 6 - 8 inches, and no more. Remove all shipping bolts at the back of washer with supplied spanner. (Refer to Step 3, 4, 5)  If the washer rocks and vibrates excessively, level your washer again. (Refer to Step 6, 7) Visits by a Service Engineer to explain functions, maintenance or installation is not covered by warranty. Connect one end of the COLD/HOT water supply hoses to the each COLD/ HOT water supply intakes at the back of the washer. Then tighten two-thirds of a For proper operation, make turn with pliers. [. . . ] Sure both Hot & Cold hoses from faucets are connected to the corresponding Hot / Cold water inlets on the washer. [. . . ]